|
|
|
|
|
|
|
|
|
|
|
|
|
|
Designed to meet the spacing requirements of the 1990 National Electrical Code, article 300-4-(d). Allows installation of multiple NM cables on one side of a 2x4. Accepts a wide range of flat NM cables, from 1 number 14-2 AWG to 1 number 10-2 AWG. Also accepts round cables up to .30" diameter. Spaces cables to center of standard 2x4. Reduce potential heating that could occur if cables are stacked under a single fastening device. Dresses wires for professional look in exposed areas, such as panel boxes. Easy installation - cables snap in for positive lock. Simplifies cable identification. Made from reclaimed plastic.
|
Use to protect internal wire runs from nail punctures, as defined in the NEC Article 300-4
|
Fastens wires, cables, hose and ducts. DoubleLock design ensures 50 percent more tensile strength than industry standards. Flexible Nylon material allows cable ties to remain serviceable through temperature ranges of 32 to 185 degrees Fahrenheit. Recognized under component program of UL E125869. Meets flammability classification UL 94 V-2.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Secures service entrance cable. Pointed offset legs drive in straight, will not split wood. High quality carbon steel for durability and easy nailing.
|
Fastens wires, cables, hose and ducts. DoubleLock design ensures 50 percent more tensile strength than industry standards. Flexible Nylon material allows cable ties to remain serviceable through temperature ranges of 32 to 185 degrees Fahrenheit. Recognized under component program of UL E125869. Meets flammability classification UL 94 V-2.
|
Fastens wires, cables, hose and ducts. Flexible nylon material allows cable ties to remain serviceable through temperature ranges of -40 to 185 degrees Fahrenheit. Recognized under component program of UL E125869. Meets flammability classification UL 94 V-2. 18 pound tensile strength.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Fastens wires, cables, hose and ducts. DoubleLock design ensures 50 percent more tensile strength than industry standards. Flexible Nylon material allows cable ties to remain serviceable through temperature ranges of 32 to 185 degrees Fahrenheit. Recognized under component program of UL E125869. Meets flammability classification UL 94 V-2.
|
General purpose electrical insulating tape, good dielectric strength. 7 mils thick. UL Listed and CSA Certified.
|
Made from a minimum of 85% post-consumer recycled content. Nylon, the biggest ingredient in cable tie resin, is 100 percent recycled material. The process and materials used to make the Eco-Ties have been reviewed and approved by UL Environmental Agency. Durable: engineered from recycled nylon 66. Min/max operating temperature: 32 degreesF ? 185 degrees F (0 ? 85 degrees C). 50 pound tensile strength.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Fastens wires, cables, hose and ducts. DoubleLock design ensures 50 percent more tensile strength than industry standards. Flexible Nylon material allows cable ties to remain serviceable through temperature ranges of 32 to 185 degrees Fahrenheit. Recognized under component program of UL E125869. Meets flammability classification UL 94 V-2.
|
For wire tying, bundling and other fastening uses. Meets flammability classification UL94V-2.
|
For snap-in splicing of low-voltage AWG wire without prior stripping. 75 degree Celsius temperature rating. Clamshell.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Tight, square-wire spring threads directly onto conductors for fast connections with no slip. Tightens without ratcheting, easily removed for repeat usage on same size combination or larger. Fluted shell surface permits a firm grip for easy finger-tight connections. Thermoplastic shell shields against environmental extremes. Flame-retardant properties resist heat distortion up to 221 degrees Fahrenheit. Superior flash-over protection. High-dielectric shell features deep skirt design to prevent exposure of bare wire. Buttress threads screw into wire insulation. For copper to copper connections only.
|
Fastens wires, cables, hose and ducts. Flexible nylon material allows cable ties to remain serviceable through temperature ranges of -40 to 185 degrees Fahrenheit. Recognized under component program of UL E125869. Meets flammability classification UL 94 V-2. 18 pound tensile strength.
|
Fastens wires, cables, hose and ducts. DoubleLock design ensures 50 percent more tensile strength than industry standards. Flexible Nylon material allows cable ties to remain serviceable through temperature ranges of 32 to 185 degrees Fahrenheit. Recognized under component program of UL E125869. Meets flammability classification UL 94 V-2.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Tight, square-wire spring threads directly onto conductors for fast connections with no slip. Tightens without ratcheting, easily removed for repeat usage on same size combination or larger. Fluted shell surface permits a firm grip for easy finger-tight connections. Thermoplastic shell shields against environmental extremes. Flame-retardant properties resist heat distortion up to 221 degrees Fahrenheit. Superior flash-over protection. High-dielectric shell features deep skirt design to prevent exposure of bare wire. Buttress threads screw into wire insulation. For copper to copper connections only.
|
Tight, square-wire spring threads directly onto conductors for fast connections with no slip. Tightens without ratcheting, easily removed for repeat usage on same size combination or larger. Fluted shell surface permits a firm grip for easy finger-tight connections. Thermoplastic shell shields against environmental extremes. Flame-retardant properties resist heat distortion up to 221 degrees Fahrenheit. Superior flash-over protection. High-dielectric shell features deep skirt design to prevent exposure of bare wire. Buttress threads screw into wire insulation. For copper to copper connections only.
|
Tight, square-wire spring threads directly onto conductors for fast connections with no slip. Tightens without ratcheting, easily removed for repeat usage on same size combination or larger. Fluted shell surface permits a firm grip for easy finger-tight connections. Thermoplastic shell shields against environmental extremes. Flame-retardant properties resist heat distortion up to 221 degrees Fahrenheit. Superior flash-over protection. High-dielectric shell features deep skirt design to prevent exposure of bare wire. Buttress threads screw into wire insulation. For copper to copper connections only.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Tight, square-wire spring threads directly onto conductors for fast connections with no slip. Tightens without ratcheting, easily removed for repeat usage on same size combination or larger. Fluted shell surface permits a firm grip for easy finger-tight connections. Thermoplastic shell shields against environmental extremes. Flame-retardant properties resist heat distortion up to 221 degrees Fahrenheit. Superior flash-over protection. High-dielectric shell features deep skirt design to prevent exposure of bare wire. Buttress threads screw into wire insulation. For copper to copper connections only.
|
Tight, square-wire spring threads directly onto conductors for fast connections with no slip. Tightens without ratcheting, easily removed for repeat usage on same size combination or larger. Fluted shell surface permits a firm grip for easy finger-tight connections. Thermoplastic shell shields against environmental extremes. Flame-retardant properties resist heat distortion up to 221 degrees Fahrenheit. Superior flash-over protection. High-dielectric shell features deep skirt design to prevent exposure of bare wire. Buttress threads screw into wire insulation. For copper to copper connections only.
|
Easy-on, easy-off without tools. Wings are knurled for a surer grip and offset from the centerline for greater twisting leverage. Easily removed for repeat usage on same size combination or larger. Expandable square-wire plated spring instantly adjusts to the shape and size of the splice for a vibration-resistant connection. Tough thermoplastic shell shields against environmental extremes. Flame-retardant, non-porous and non-corrosive shell resists surface cracking and chemical action. Temperature rating: 221 degrees F. Superior flash-over protection. High-dielectric shell features deep skirt design to prevent exposure of bare wire. Buttress threads screw into wire insulation. Copper to copper connections only. cULus Listed.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Easy-on, easy-off without tools. Wings are knurled for a surer grip and offset from the centerline for greater twisting leverage. Easily removed for repeat usage on same size combination or larger. Expandable square-wire plated spring instantly adjusts to the shape and size of the splice for a vibration-resistant connection. Tough thermoplastic shell shields against environmental extremes. Flame-retardant, non-porous and non-corrosive shell resists surface cracking and chemical action. Temperature rating: 221 degrees F. Superior flash-over protection. High-dielectric shell features deep skirt design to prevent exposure of bare wire. Buttress threads screw into wire insulation. Copper to copper connections only. cULus Listed.
|
Easy-on, easy-off without tools. Wings are knurled for a surer grip and offset from the centerline for greater twisting leverage. Easily removed for repeat usage on same size combination or larger. Expandable square-wire plated spring instantly adjusts to the shape and size of the splice for a vibration-resistant connection. Tough thermoplastic shell shields against environmental extremes. Flame-retardant, non-porous and non-corrosive shell resists surface cracking and chemical action. Temperature rating: 221 degrees F. Superior flash-over protection. High-dielectric shell features deep skirt design to prevent exposure of bare wire. Buttress threads screw into wire insulation. Copper to copper connections only. cULus Listed.
|
Easy-on, easy-off without tools. Wings are knurled for a surer grip and offset from the centerline for greater twisting leverage. Easily removed for repeat usage on same size combination or larger. Expandable square-wire plated spring instantly adjusts to the shape and size of the splice for a vibration-resistant connection. Tough thermoplastic shell shields against environmental extremes. Flame-retardant, non-porous and non-corrosive shell resists surface cracking and chemical action. Temperature rating: 221 degrees F. Superior flash-over protection. High-dielectric shell features deep skirt design to prevent exposure of bare wire. Buttress threads screw into wire insulation. Copper to copper connections only. cULus Listed.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
For wire tying, bundling and other fastening uses. Meets flammability classification UL94V-2.
|
Specifically designed for making positive ground connections. Connectors feature the same live-action as WingGard connectors with the added plating protection for corrosion resistance in grounding applications. Contoured, offset wings enable firm ground connections with the twist of a hand. Flame retardant, themoplastic shell resists punctures, cuts, abrasion and corrosion. Connectors have a hole in the tip for ground wire. Solid copper to copper connections only. Nos. 15-095; 19-095 and 25-095: minimum 2 #14, maximum 4 #12 wire connections.
|
Two-wire staples fasten 2 and 3 conductor non-metallic cable. SIZE: 1/2" x 1" - For 2 conductor (No. 12 and No. 14) NM cable. SIZE: 9/16" x 1-1/4" - For 3 conductor (No. 10 and No. 12) NM, BX, UF and other cable.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Black PVC electrical tape is UL Listed to 600 volt. 7.5 mil. thickness and a temperature rating up to 80 degrees Celsius/176 degrees Fahrenheit. Elongation of 200 percent allows tight wrapping and sealing.
|
GB Insulated Clamp, 3/8 in Opening, Steel, Black, Rubber Cushion
|
Flexible shape conforms to wires and cables. Holds harnesses, cables and tubing for construction, maintenance and assembly-line operations. Tough, durable, yet extremely lightweight with clean, smooth edges for easy handling. Working temperature range of -66 to 340 degrees F.
|
|
|
